Launch MCU3 adapter
This is a 6T50 transmission control module out of a 2014 Chevrolet Camaro. The shop just replaced the transmission with the used one. The only way to make
How to renew Mercedes Benz W204 ELV, make it virgin then you can write EIS data using Launch X431 Tools. Tools used: Launch X431 tablets (X431 V+ V5, X431
Launch X431 X-prog3 programmer is very good at ECU/TCU cloning. Here comes an example of Mercedes Benz VGS NAG3 gearbox cloning. Device required: Launch X431 X431 PAD VII/PAD V series or
Problem: I did read few edc17 ecu no issue with Launch X-prog3 programmer but now it’s 3 ecu edc16 I just can’t connect it on bench. Solution: You
Launch X431 V/PAD has the wiring diagram to a part that’s not included with the xprog3. Where can i get the adapter for xprog3 mcu3? Solution: All functions