It’s very useful to check and upgrade BMW FEM or BDC software version with Autel IM608 Pro II before attempting key programming or removing the module. Because some software versions are not supported by Autel. Some versions (BDC) can be done via OBD.
Here we will show how to check and update BMW FEM/BDC version by IM608 II.
How to check FEM/BDC software version?
IMMO >> Accept >> BMW >> Automatic selection >> Read >> OK >> Yes >> Control unit >> FEM/BDC Immobilizer >> Vehicle information
Here we can check the software information.
Escape to enter into “Special function >> Version detect”.
It says: “The current ECU software version is supported”.
Once we see this message, we can continue with key programming process. We shouldn’t run into any hiccups.
How to upgrade FEM/BDC software version?
But if you’ve seen that “The current ECU software version is not supported”, you’ll have to try to update software version.
Programming operation >> ECU upgrade
Note:This process requires a network connection for data acquisition. Check the network settings to ensure a connection to Wi-Fi and maintain the network connection during the process.
Press “OK”.
The current ECU software version is supported and no ECU upgrade is required.
So if it wasn’t supported, you’ll go to this programming or upgrade process. This may take about 8-10 minutes. Then it’ll upgrade to a supported version so that you can process with key programming
The ECU upgrade is used for upgrade programming for ECU. It solves the problem that some software version of FEM/BDC are not supported.
This is how to use Autel IM608 II to check and upgrade BMW FEM/BDC software version before key programming.
www.obdii365.com
