This is a Nissan Note 2007 (automatic, right wheel, Intelligent Key). There is a working key, customer need to add chip key startup.
(Note: The tutorial is translated from Russian, for educational purpose only)
Diagnostic device ABRITES Vehicle Diagnostic Interface , when selecting (Nissan Note 2006+) requires a 12-digit PIN code, which is presumably considered for label located behind the glove compartment (glove box).
But the car has a sticker, so the chip should be registered with the device SBB Key Programmer.
How to calculate PIN code for registration key / chip in the car?
PIN will be assumed by the label BCM, with the help of the program AD600 Code Wizard Pro (Demo the Version) , which can be downloaded at this link. Or by hand-held Nissan Pin code reader NSPC001.
To perform this procedure, you’ll need:
- Net HITAG 2 transponder – PCF7936.
- Wires (jumpers), for supplying power to the ignition contacts.
How to register the vehicle key / chip on Nissan Note using SBB Key Programmer?
1. Insert the device connector SBB v46.02 in OBDII vehicle.
2. The instrument select NISSAN JAPAN – the MICRA MARCH 00- – Gasoline
3. Then Insert a key and turn on the console – Insert the key into the lock, and turn the ignition switch on.
4. The instrument choose NATS 5 – the PROG. NEW KEYS.
5. Without the PIN CODE you CAN not program new keys – Without a PIN, you can not program the new keys.
6. Enter the 4-digit PIN number, counted on the label BCM.
7. Insert keys to be programmed in sequence and turn them on and off for 5 sec respectively. In the end start the engine for some sec. Press any key … Press – Insert the key to be programmed in sequence, one after the other, on and off the ignition for 5 seconds. After the end of the programming start the engine.
8. Once the button is pressed all quickly, without errors:
- LED standard signaling, in the right corner at the windshield starts to blink.
- Turning off the ignition, take out a sting from the ignition.
- We put a thorn in the ignition, turn the ignition.
- Turning off the ignition, take out a sting from the ignition.
- Place the transponder antenna on the ignition.
- Provide the + 12V on wire and KEY IN KEY PUSH (red-blue and red and white, respectively).
- Turning on the ignition by supply of + 12V to the corresponding contacts ignition.
- Turn off the ignition.
- We start the engine.
